Contrex MLP-Trim Manual do Utilizador descarregar pdf (Página 170)

C - 2

CP-06 DIRECT SETPOINT

Use the Direct Setpoint (CP-06) to set the drive output that is used when the MLP–Trim is in the

Direct Mode of operation. Direct mode is an open-loop mode of operation. Scaling,

Acceleration/Deceleration, and closed loop compensation (PID) software are not involved in the

Direct mode. The Direct mode is used in conjunction with the Run and Stop controls.

CP-08 MINIMUM LIMIT

This parameter sets the minimum level of operation in the Run state. It is possible to enter a

setpoint below this limit, however, the control will always attempt to maintain a speed at or above

this RPM level.

CP-09 MAXIMUM LIMIT

This parameter sets the maximum level of operation in the Run state. It is possible to enter a

setpoint above this limit, however, the control will always attempt to maintain a speed at or below

this RPM level.

CP-10 ALARM 1 FORMAT

By entering alarm Control Parameters, you can establish circumstances under which the

MLP–Trim will alert you to potential operating problems. The alarm can be wired to activate a

warning light, a warning sound, or to shut down the system under specified conditions. Alarm

Format (CP-10) determines which alarm conditions will activate the Dig_Out1 output, using the

values that are entered in Low Alarm (CP-12), High Alarm (CP-13), Ramped Error Alarm (CP-14)

and Scaled Error Alarm (CP-15).

0 = No Alarm 8 = Scaled Error

1 = Low Alarm 9 = Low Alarm or Scaled Error

2 = High Alarm 10 = High Alarm or Scaled Error

3 = Low Alarm or High Alarm 11 = Low Alarm or High Alarm or Scaled Error

4 = Ramped Error 12 = Ramped Error or Scaled Error

5 = Low Alarm or Ramped Error 13 = Low Alarm or Ramped Error or Scaled Error

6 = High Alarm or Ramped Error 14 = High Alarm or Ramped Error or Scaled Error

7 = Low Alarm or High Alarm 15 = Low Alarm or High Alarm or Ramped Error or

or Ramped Error Scaled Error

16 = Drive Enable

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 215 216

Sem comentários

Contrex MLP-Trim Manual do Utilizador Página 170