Contrex M-Traverse Manual do Utilizador descarregar pdf (Página 56)

3 - 9

Control Mode Parameter

The Control Mode (CP-14) parameter allows you to choose between either the

Standard (1) or Lay Adjusted (3) option in the Follower mode of operation. Both options

will operate your system. The calculation of the Follower profile length is the only

difference between the Standard and the Lay Adjusted option. In the lay adjusted

option, one lay pitch is subtracted from the profile length to adjust for the initial lay on

the reel.

NOTE: You can also use Control Mode (CP-14) to choose the Direct mode of opera-

tion, which is used for calibration and trouble shooting. Refer to

Operation:

Direct Mode

for information on the Direct mode.

The factory default for the Control Mode Control Parameter is found in Table 3-2. To

modify the default parameter refer to Table 3-3. If you are uncertain how to enter a

Control Parameter, review the

Operations: Keypad

section.

Table 3-2 Default Control Mode Control Parameter

CP Parameter Name Parameter Value

CP-14 Control Mode 1 (Follower /Standard)

Table 3-3 Entering Control Mode Control Parameters

CP-14 Control Mode Enter “1” to enable the Follower Mode / Standard

Enter “3” to enable the Follower Mode / Lay Adjusted

CP Parameter Name Parameter Value

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 201 202

Sem comentários

Contrex M-Traverse Manual do Utilizador Página 56