Contrex M-Traverse Manual do Utilizador descarregar pdf (Página 70)

3 - 23

Table 3-14 Default Control Parameters for Changes

CP Parameter Name Parameter Value

CP-24 Edge/Center Based 1

CP-25 Change Activation 1

CP-30 At-Home Band 4

CP-31 Home Offset 0

Table 3-15 Entering Control Parameters for Changes

CP Parameter Name Parameter Value

CP-24 Edge/Center Based Enter “1” for an edge based profile.

Enter “2” for a center based profile.

CP-25 Change Activation When CP-24 is set to “1” (edge based), then:

Enter “1” to activate changes when the Follower is in

the “Home position.

Enter “2” to activate changes immediately.

Enter “3” to activate changes when the Follower is in

the end dwell position.

CP-30 At-Home Band Enter the number of encoder lines that you want to

allow on either side of the “0” Home Set position.

CP-31 Home Offset If CP-24 is set at “1” (edge based), enter the distance

from the sensor to the desired position of “Home”.

If CP-24 is set at “2” (center based), enter the distance

from the sensor to the center of the web.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 201 202

Sem comentários

Contrex M-Traverse Manual do Utilizador Página 70