Contrex MLP-Trim Manual do Utilizador descarregar pdf (Página 122)

3 - 82

Control Command Send

The Control Command Send allows the host computer to control the operating

functions of the MLP–Trim that are associated with the digital inputs (Run, Stop,

Setpoint Select and Master/Follower).

Table 3-53 Control Command Send - Host Transmission

Character # 1 2 3 4 5 6 7 8 9 10 11 12

DEV # DEV # MSG PAR # PAR # DATA DATA DATA DATA DATA

DESC STX 10s 1s TYPE 10s 1s 1000s 100s 10s 1s FORM ETX

ASCII STX 0-9 0-9 1 0 0 0 0 0-1 0-9 0 ETX

The following is a description of the Control Command Send - Host Transmission.

Character 1 - STX:

This is the first character in the character string. None of the other characters will

be recognized without this character prefix. Always use the ASCII “STX” character;

it enables the MLP–Trims receive buffer.

Characters 2, 3 - Device #:

These characters are the access address of the MLP–Trim. This number identifies

individual MLP–Trims on a mutltidrop system. The MLP–Trim will accept data only

if this number matches the MLP–Trim's address (CP-70), with the exception of a

“00” address. The “00” address is universally accepted by all MLP–Trims that are

on the RS485 Serial Communications Interface.

Character 4 - Message Type:

This character should always be “1”.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 215 216

Sem comentários

Contrex MLP-Trim Manual do Utilizador Página 122