Contrex MLP-Trim Manual do Utilizador descarregar pdf (Página 94)

3 - 54

Limits

The MLP-Trim has the ablity to limit both the minimum and maximum operating speed

when in the Run state.

The following control parameters are used by the MLP-Trim for limit control:

Minimum Limit (CP-08)

This parameter sets the minimum level of operation in the Run state. It

is possible to enter a setpoint below this limit, however, the control will

always attempt to maintain a speed at or above this RPM level.

Maximum Limit (CP-09)

This parameter sets the maximum level of operation in the Run state. It

is possible to enter a setpoint above this limit, however, the control will

always attempt to maintain a speed at or below this RPM level.

Table 3-45 Default Limit Control Parameters

CP Parameter Name Parameter Value

CP-08 Minimum Limit 0

CP-09 Maximum Limit 2000

Table 3-46 Entering Limit Control Parameters

CP Parameter Name Parameter Value

CP-08 Minimum Limit

CP-09 Maximum Limit

Enter the desired minimum operating RPM.

Enter the desired maximum operating RPM.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 215 216

Sem comentários

Contrex MLP-Trim Manual do Utilizador Página 94